Hello everyone!!!

Ok...now I understand my pajero has an autolock systems for the hubs, so I wanted to use it just to see the differencie but I...

I need to find out what the spline count is on the outer cv joints for my 2001 3.5 SWB Auto. Apparantly there are 3 variations available. Anybody...

Had a knock from the front and decided to redo the front suspension. Removed everything to find the outside bearing on the right frint axle to be...

Picked up this thread
and I am interested to know if the Gen 2's came out with 31x9.5x15's? Also what exactly is done when changing gear ratio to...

Hello Everyone

I have a 2000 3.5 Blister swb and have a noise on the rear diff. Is there bearing kits on the market for this? Can anyone supply me...

Hi Guys

I replaced my transfer case lever yesterday ,the ball in the old one was badly worn .After i did this my dash lights went all wonky and i...

Hi

I am new on your forum and would like some advice if you do not mind.

I got the Vehicle on Saturday thinking is was in a good condition but...

Hi Guys,

I'm the proud owner of the above mentioned vehicle and I must say I love this car to bits! I bought it second hand in February this year...

Hi All

I have taken out my gearbox this weekend and need some advise. I think (mever seen one before now) has come to the end of its lifespan...

Hi Guys,

I have a small issue with my Gen 3 Auto torque converter (I think).

History:
I have a '04 3.2 SWB Auto with about 150 000km on. About 10...

Where on the website can I download the pdf's required for the above ? Keith. :roll:

Hello,

I am a new guy with 4x4 and also Pajero, I own a Gen1 and I read there is something on the front wheels that specify there is a chance to...

Hello all! I'm a newbie to the forum and South Africa. My family and I moved here from America about 6 weeks ago to be missionaries and needed a...

Hi Guys

I've got a wo wo wo wo wo wo wo noise coming from somewhere. I presume its some where on the drivetrain (and guessing its the wheelbearings)...

Hi All,

I need to know the type (code) gearbox is in my Gen 2. It is a manual 1996 2,8 TDI Pajero with the 4M40 engine. It seems like it was one of...

Some notes on the install of the aussie locker

My front diff lock is finally in

One or two comments:

While both are gear oils and are available in many different viscosity grades, the difference between GL-4 and GL-5 oils is...

I find the Gen 3 Paj is a bit fast going down in 1st gear on compression. I find that am forced to use my brakes more than I would on a manual...

I have a 2008 3.2 litre Diesel 3 door Pajero with 40 000 kms on the clock. I have had a gearbox failure that the dealer claims is due to water mixing...

I am a little concerned that something isnt 100% on my auto box.

Last week whilst braking the revs shot up to about 2500 for a few seconds before...

hi guys does any one know if i can replace my rear diff on a 3.0 auto pajero 2 with a 3.5 manual pajero 2 and will it affect the gearing on the auto...

Hello everyone,

I am new on this forum. I bought a 2000 or 2001 Gen 3 Pajero 3.5 V6 LWB a couple weeks ago and then found this Forum and decided to...

Hi Everybody,
Can someone please tell me what oil to use for the transfer box. Mineral or sinthetic ?
What make will do the job here?????
Thanks

I bought a set of inner/outer cv boot covers from the local Mitsu dealer in PE today. Upon opening them at home I discovered that the outer boot is...