[CATS]

I got mine made at Org from Tough Stuff in Pretoria. Mine was the first Gen3 NM lwb that he did. Maybe I must chat to him to make some for the club as I am sure he has all the templates by now. If made according to a template they can be couriered anywhere and just bolted on.

I will contact him this week and see what I can organize.

CATS

[Lazy-Days]

I got mine made at Org from Tough Stuff in Pretoria. Mine was the first Gen3 NM lwb that he did. Maybe I must chat to him to make some for the club as I am sure he has all the templates by now. If made according to a template they can be couriered anywhere and just bolted on.

I will contact him this week and see what I can organize.

CATS

I'll also be interested in a set for my 2002 SWB 3.2DiD.

Currently I still have the silver factory fitted pipes on the side... maybe someone would like to take them over from me?

[CATS]

I got mine made at Org from Tough Stuff in Pretoria. Mine was the first Gen3 NM lwb that he did. Maybe I must chat to him to make some for the club as I am sure he has all the templates by now. If made according to a template they can be couriered anywhere and just bolted on.

I will contact him this week and see what I can organize.

CATS

I spoke to Org and unfortunately he has decided to close that business a few months ago. He says that the amount of steel going into a proper rockslider is more than a bumper replacement costing R8000, but people are loath to pay that kind of money for the sliders. Thus he has decided to call it a day. Sorry guys, I tried.

The only other place that makes sliders for the Pajero here in Gauteng is Lynx 4x4. But their setup does not include hi-lift points and they said that they are not willing to adjust the design as they are unwilling to fit lifting points on the side rails of the monocoque Gen3/4 Pajero chassis. Maybe they will do front and back though. Give them a call.

CATS

[Gemaskerde Tuinvurk]

When last did you check with Lynx? I mailed them last month, and they reckoned they would look into putting high lift points on their rock sliders for the Gen4... maybe someone new there?

Allegro from the 4x4 forum has apparently had good dealings with Jan from Creative exhaust in Silverton Pta. You can see what he built for a Gen3 in the attached image. He was quoted around R3200...

Also, Uys also seems keen to make rock sliders, but is not convinced about putting high-lift jack points... but we can maybe convince him to do it...

[CATS]

When last did you check with Lynx? I mailed them last month, and they reckoned they would look into putting high lift points on their rock sliders for the Gen4... maybe someone new there?

I spoke to them about a year ago, so it is possible.

CATS