Page 1 of 1

Using a USB Device

Posted: Thu Oct 08, 2015 8:34 am
by Going 4x4
Guys,
I recently acquired a new SWB, 2015 model with the same Audio set-up as I had in my ASX (previous vehicle). However, using the same Usb device in the new Pajero, I cannot seem get the set-up correct. Presently it works, but obviously there are various tracks (music folders) on this device but whenever I kill the ignition and restart the vehicle again, it automatically go back to the 1st track on the device whereas in the past, my previous vehicle, it would carry on playing the track prior to switching it off. Surely there must me a setting somewhere which I miss and would appreciate your advise.
Regards,
Johan

Re: Using a USB Device

Posted: Thu Oct 08, 2015 9:01 am
by Roelf_le_Roux
Hi Johan.

Have you checked what the owner's manual has to say about this?

Re: Using a USB Device

Posted: Thu Oct 08, 2015 4:03 pm
by JohnG
I am not 100% sure anymore but i know that while the usb is in and playing you push and hold one of the buttons on the radio either the TP or one of those..This sets the memory to remember where the last track stopped..If I can find where I read this i will try and post,but look in the manual,it might state it there

Re: Using a USB Device

Posted: Mon Oct 12, 2015 8:19 am
by thomasg
I had the same problem with my 2015 Pajero and reported it to the dealer who managed to sort it out.