Pajero Owners Club of South Africa

Guys,
Some advise here.
I need to remove the passenger side rear panel in the luggage compartment of my Pajero Gen 4 SWB (2015) to get inside for the fitment of a proper Brad Harrison Plug for running a fridge. The side where the lighter socket is situated which I will keep in place.
Any-one out there who can supply me with some drawings/diagrams/sketches etc. I don't want to take the complete vehicle apart for this seemingly easy job.
Thanks,
Johan

Since I am still without a reply I need to post question nr 2 and that is where to run the 16mm cables to reach the rear.
Options are:
1. Through the firewall underneath plastic passenger side door entrance and under the carpet to the rear.
2. Underneath the bodywork, as high as possible, possibly follow an existing wire/wiring.
3. Fish-tape it through the passenger side a-pillar, through the roof section and then find a opening to bring it down into the luggage area.
Anybody wishes to advise?
Johan

I ran my cable underneath the vehicle inside a flexible conduit cable tied to existing pipes and cables.

Sent from my GT-I9195I using Tapatalk

Hi Johan

I also wanted to remove the rear passanger side panel and had no success.

I ran my cables through the fron firewall (big wiring loom) up the front passanger side a-pillar, through the roof section and then down the rear into the luggage area.

Have a look at the article I posted https://www.pajeroclub.co.za/forum/view ... =27&t=4669

Hope this helps.

Paul